Delta Cryogenic Second Stage

Delta Cryogenic Second Stage

A 4-meter DCSS from a Delta IV Medium
Manufacturer	Boeing United Launch Alliance Mitsubishi (Delta III) NASDA (design)
Country of origin	United States Japan (Delta III)
Used on	Delta III Delta IV SLS Block I
Launch history
Status	Active
Total launches	45
Successes (stage only)	42
Failed	2 (Delta III)
Lower stage failed	1 (Delta III)
First flight	27 August 1998
Delta III second stage
Height	8.8 m (29 ft)
Diameter	4 m (13 ft) (LH2 tank) 3.2 m (10 ft) (LOX tank)
Empty mass	2,480 kg (5,470 lb)
Gross mass	19,300 kg (42,500 lb)
Powered by	1 × RL10B-2
Maximum thrust	110.1 kN (24,800 lbf)
Specific impulse	462 s (4.53 km/s)
Burn time	700 seconds
Propellant	LH2/LOX
Delta IV 4-meter second stage
Height	12.2 m (40 ft)
Diameter	4 m (13 ft) (LH2 tank) 3.2 m (10 ft) (LOX tank)
Empty mass	2,850 kg (6,280 lb)
Gross mass	24,170 kg (53,290 lb)
Powered by	1 × RL10B-2
Maximum thrust	110.1 kN (24,800 lbf)
Specific impulse	462 s (4.53 km/s)
Burn time	850 seconds
Propellant	LH2/LOX
Delta IV 5-meter second stage
Height	13.7 m (45 ft)
Diameter	5 m (16 ft) (LH2 tank) 3.2 m (10 ft) (LOX tank)
Empty mass	3,490 kg (7,690 lb)
Gross mass	30,710 kg (67,700 lb)
Powered by	1 × RL10B-2
Maximum thrust	110.1 kN (24,800 lbf)
Specific impulse	462 s (4.53 km/s)
Burn time	1,125 seconds
Propellant	LH2/LOX
Interim Cryogenic Propulsion Stage
Height	13.7 m (45 ft)
Diameter	5 m (16 ft) (LH2 tank) 3.2 m (10 ft) (LOX tank)
Empty mass	3,800 kg (8,400 lb)
Gross mass	32,748 kg (72,197 lb)
Powered by	1 × RL10B-2 or RL10C-2
Maximum thrust	110.1 kN (24,800 lbf)
Specific impulse	462 s (4.53 km/s)
Burn time	1,125 seconds
Propellant	LH2/LOX

The Delta Cryogenic Second Stage (DCSS) is a family of cryogenic-fuelled rocket stages used on the Delta III, Delta IV, and on the Space Launch System Block 1 launch vehicles. The DCSS employs a unique two-tank architecture where the cylindrical liquid hydrogen (LH₂) tank carries payload launch loads and forms the upper section. An oblate spheroid tank filled with liquid oxygen (LOX) and the engine are suspended from the LH₂ tank and covered by the interstage during initial launch.

The DCSS is powered by a single RL10B-2 engine built by Aerojet Rocketdyne, which features an extendable carbon–carbon nozzle to improve specific impulse.

The DCSS was designed by the National Space Development Agency of Japan, based on the second stage it developed for the H-IIA rocket. The initial versions for the Delta III were built by Mitsubishi Heavy Industries in Japan. For the Delta IV, production was transferred to Boeing Integrated Defense Systems and later to United Launch Alliance.

Delta III

The DCSS first flew on three Delta III missions, however it was never successful. On its maiden flight, a booster failed and the rocket was destroyed by range safety, causing the loss of the DCSS

The Delta III upper stage being tested in January 1998

before ignition. The second mission saw the DCSS itself malfunction tumbling uncontrollably, inserting the payload into a useless orbit. On the third flight, the DCSS performed its planned burn but fell short of the target orbit due to premature propellant exhaustion, resulting in mission failure. An un-flown example is on display outside the Discovery Cube Orange County.

Delta IV

The Delta IV launch vehicle utilized two distinct versions of the Delta Cryogenic Second Stage (DCSS) to cater to the specific launch needs. These variants are the original DCSS with a 4-meter (13 ft) diameter that is largely identical to the version used on the Delta III and the larger version with a 5-meter (16 ft) diameter used to lift larger payloads.

These variations necessitated the use of composite interstages, which linked the first and second stages together. For the Delta IV Medium configuration, a tapering interstage was employed to transition between the 5-meter diameter of the first stage and the smaller 4-meter diameter of the DCSS. In contrast, the Delta IV Heavy configuration and some Delta IV Medium+ configurations, with larger payload capacities, utilized a cylindrical interstage that matched the diameter of its 5-meter DCSS.

The Delta IV family of rockets has been retired, with a final launch on 9 April 2024.

Interim Cryogenic Propulsion Stage

The Interim Cryogenic Propulsion Stage (ICPS) serves as the upper stage for the initial configuration (Block 1) of NASA's Space Launch System (SLS). It's a derivative of the 5-meter DCSS, with minimal modifications for SLS integration. Like the earlier DCSS, the ICPS is powered by one Aerojet Rocketdyne RL10 engine and generates 110.1 kilonewtons (24,800 pounds-force) of maximum thrust. Like all previous DCSS units, Artemis I used the RL10B-2 engine, however Artemis II and III will use the RL10C-2.

The ICPS for the Artemis I mission was mated to the SLS launch stack on 6 July 2021. It performed as expected, providing the necessary thrust during the successful launch on 16 November 2022 at 06:47:44 UTC (01:47:44 EST).

The ICPS is designed as a temporary solution and slated to be replaced by the next-generation Exploration Upper Stage for the Artemis IV mission and beyond.

The Artemis I ICPS under construction

External links

• Official ULAlaunch ICPS Photo album